News

The requirements for the correct use of the battery are as follows:

1. Do not use the starter continuously. The starting time of the water well drilling rig should not exceed 5 seconds each time. If it fails to start normally once, it should be stopped for 15 seconds before starting the second time. If the start is unsuccessful for three consecutive times, the cause should be found out and other faults of the water well drilling rig should be eliminated before Start the engine.

2. In severe cold regions, the battery should be insulated in winter.

3. When installing and handling the battery, it should be handled with care, and it should not be knocked or dragged on the ground. The battery should be firmly on the drilling rig to prevent vibration and displacement.

Battery maintenance requirements for water well drilling rigs are as follows:

1. Always remove the dirt on the surface of the battery, and remove the oxides on the electrode piles and wire clamps in time.

2. Always unclog the vent hole on the filler cap.

3. The discharged battery should be charged within 24 hours.

4. The used vehicle battery should be recharged every two months.

5. Commonly used batteries should be charged when the discharge level reaches 25% in winter and reaches the target 50% in summer.

6. When disassembling the battery, first remove the negative electrode of the battery, and then remove the positive electrode of the battery; when installing the battery cable, install the positive electrode of the battery first, and then install the negative electrode of the battery, so as to avoid the disconnection of the battery during the disassembly process.